Guide overlay
Maizena 3D Prints with Liquid Polymers
Posted by 3DP4E
INNOVATIONS
MATERIALS

by Staff | Fabbaloo

You’ll need some plastic filament for your extruder, correct? Not so if you happen to use an extruder from Maizena. It prints liquid!

Specifically, the extruder uses a mixture of corn starch and water, extruded under pressure. In the image above you can see the liquid mix entering the extruder through a tube. No filament!

The Maizena team has been investigating approaches to liquid printing and came up with a design that seems to work. There are a couple of advantages of such a system: less power is required due to the absence of a heating requirement; extremely inexpensive material, as corn starch is commonly available at very low prices compared to any plastic filament.

It’s an interesting approach that certainly deserves some investigation. We’re a bit skeptical about the utility of the prints, however. How robust are they? Would the finish, resolution and strength compare with ABS or PLA prints? What kind of overhangs are possible when printing?

We’re certain Maizena is checking all this out and we’re interested to see the results.

Link to Original Article

Share
0 Comments

Please login to post a comment.

247d01deb57af829ba8e1cda046aa3284ed5b14c thumb
Posted on April 1, 2014
SPACE

By Jacqueline Howard | The Huffington Post

8e876cd070425c5f3b1f124752cf0bf6234b6441 thumb
Posted on October 2, 2014
PRINTERS
SOFTWARE
D.I.Y.
FUTURE

By Nora Woloszczuk | PFSK